The Alber MPM-100 Battery Monitoring System has been discontinued. This system is primarily used in telecom, utilities, switchgear and generator startup battery applications.
The Alber MPM-100 Battery Monitoring System has been replaced with the following products:
The replacement products are the new UXIM Battery Monitor (Universal Xplorer Industrial Monitor) for 120V battery configurations and the new UXTM Battery Monitor (Universal Xplorer Telecom Monitor) for 24V and 48V battery configurations. Key, standard parameters monitored are:
● Module / Cell Voltage
● String Voltage
● Discharge Current
● Ripple Current
● Float Current
● Inter Cell Measurements
● Ohmic Measurements (DC)
Favorable pricing combined with the optional Battery Xplorer Enterprise (BXE) software, the UXIM and UXTM Battery Monitors will exceed the MPM-100 in the markets they serve.
The MPM-100 Battery Monitoring System has been discontinued.
Albér's Cellular MPM Battery Monitor Says "No Problem!" to Remote Areas and Critical Systems.
● Utilizes the well proven Albér DC resistance test method
● Monitors all critical battery parameters
● Can be mounted in 19" racks or flush to the wall
Now battery monitoring is possible in even the most remote areas. Albér's cellular modem equipped MPM-100 takes advantage of well established cellular architecture to let you install a monitoring system virtually anywhere you have batteries. The MPM-100 is the perfect battery monitor for your central office, outside plant (OSP), wireless base station or radio base station.
During setup, simply open the MPM and insert a service activated SIM card into the modem. Close the unit, connect the antenna, then install the MPM system as instructed. A few moments after power up, the MPM establishes communication with your cellular provider and you're ready to go!
Using selections you make during setup, your Central computer will poll the MPM at the times you specify. Additionally, depending on cellular service in your area, the MPM can call out on alarm.